<%@LANGUAGE="VBSCRIPT" CODEPAGE="65001"%> The maintenace and protection of cone crushers -- Mining machinery manufacturers Vipeak
Home About Us News Stone Crusher mobile crusher International Trade Service Contact Us
  NEWS CENTER

The maintenace and protection of cone crushers
    Vipeak Cone crusher is suitable to crush various kinds of ores and rocks of medium or above medium hardness,and cone crusher is of stable structure, high efficiency, easy adjustment, and use economically, etc. The spring safety system of crusher acts as an overloading protection system that allows metals to pass through the crushing chamber so as not to damage the cone crusher.The safety system uses dry oil and water as two kinds of sealed formation to make plaster powder and engine oil separated to make surereliable performance. The type of crushing chamber depends upon the size of feeding and fineness of the crushed product. The standard type(PYB) is applied to medium crushing, the medium type is applied to medium or fine crushing and the short head type is applied to fine crushing. According to stave work need of Cone crusher, cone crusher is maily usely in the compressive strength not surpassing 300Mpa each kind of ore and rock to medium crush and in broken bits .this is a typical equipment of our country for crushing hard ore to medium crush and broken bits.it is widely applied.it has the charateristics of high reduction ratio, high output,,few powder lost, , the product granularity even, strong compatibility of hard grain.
    Hydraulic Cylinders (typically actuated by noble gasses like nitrogen vs hydraulic oil) can collapse the springs and allow uncrushable material to exit the cone. This can be automatically actuated should the cone stop motion during operation. cone crusher Beveled GearsThis gear set translates the horizontal rotary motion of the counter shaft into the vertical rotary motion of the main shaft. They are typically forged and cut for strength and low noise. Top Cell LinersMaterial to be crushed enters the cone chamber through something called the top cell, which is typically lined with manganese liners. A device called a rotary feed distributor is sometimes added to the top cell to distribute the input material evenly throughout the bowl. When feeding a cone from a screen the rock obviously is always entering the crushing chamber on one side of the bowl only, the rotary feed distributor slings the materials around both side of the cone head, filling the crushing chamber more evenly resulting in potentially a better wear pattern and even better gradation from the full choke fed feed chamber.
    Cone Crusher Mantle Diameter cone crusher come in different sizes depending on desired production output rates. This size also determines the maximum diameter of input material the cone crusher can handle. Fine vs Standard Head Size This has to do with the clearance built into the mantle in terms of its distance from the liners. Fine heads have less clearance and can produce a finer output product while standard heads allow for a larger output product. Remote Adjustment in Cone Crushers Remote adjusters in Cone Crushers are a quite valuable feature, often adding $100,000 to $150,000 to the price of a unit. They allow for "on-the-fly" adjustment of the mantle/liner clearance distance. If you don't have this feature you must stop the crusher and adjust it with wrenches. Some manufacturers included this as a standard feature.Article from:http://www.infostonecrusher.com
VIPEAK E-CATALOGUE
download
  NEWS CENTER
Corporation News
Product Knowledge
  ABOUT VIPEAK
Brief Introduction Of Our Company
International Trade
Corporation Culture
Scientific Research and Development
After-Sales Service
Tel(Shanghai): 0086-21-51382188  E-mail: vipeak@vipeakgroup.com
Tel(Zhengzhou): 0086-371-67771000  E-mail: info@vipeak.com
Vipeak Heavy Industry Machinery Co., Ltd.